Trotec TAC XT 18, Original Instructions Manual, Page: 22 / 59

22 EN vertical heater TAC XT 18 / TAC XT 27
4. Remove the HEPA filter ( 10 ) and the filter insert ( 11 ) from
the device.
10
11
5. Put the worn HEPA filter in a bag and dispose of it in the
waste.
6. Thoroughly clean the housing from the inside and outside
(see Cleaning the housing).
7. Reinsert both the filter insert ( 11 ) and the new HEPA filter
into the device.
10
11
8. Fit the blowing-out tower ( 1 ) back on the device.
1
9. Fasten the blowing-out tower by means of the screws.
10. Put the protective caps back on the screws.
Please proceed as follows to change the prefilter:
1. Loosen the screws on the air inlet ( 8 ) on both sides and
pull out the air inlet towards the front of the device.
2. Remove the prefilter ( 21 ).
8
21
3. Insert the new prefilter into the device.
ð
Observe the installation direction. The black fleece must
be on the outside.
4. Put the air inlet ( 8 ) back on the device and tighten the
screws on both insides of the device.
21 8