Trotec TAC XT 18, Original Instructions Manual

Page: 18 / 59

18 EN vertical heater TAC XT 18 / TAC XT 27
5. Press the Fan s button in the Room decontamination
setpoint screen.
6. Press the % specification button to set the air volume flow
in the next screen via the arrow buttons.
7. Press the Configuration button in the Room
decontamination setpoint screen to save the settings.
8. Press the Back button to return to the Room
decontamination configuration screen.
9. Press the Timer mode button.
ð
The screen for setting the timer mode will appear.
10. Press the Operating duration , the Treatment duration or the
Continuous operation button.
ð
The settings for the operating duration, treatment
duration and continuous operation cannot be activated
in parallel.
ð
When selecting the operating duration or treatment
duration, the supply temperature is maintained at a
constant level.
ð
With the activation of the treatment duration, the time
that has been set starts running as soon as the room
temperature set is reached.
ð
With the activation of the operating duration, the time
starts running as soon as the device is switched on.
ð
With activation of continuous operation, the device must
be switched off manually.
11. Press the Back button to return to the Room
decontamination configuration screen.
Switch-off
Warning of hot surface
Parts of this appliance can become very hot and cause
burns. Particular attention is to be paid when there are
children or vulnerable persons present!
Warning of hot surface
The room temperature may increase up to 75 °C
during operation.
Note that the surfaces in the room may be hot after the
treatment.
1. Actuate the Off or Start/Stop button ( 18 ) in the main menu
display on the device. Once the timer has been
programmed, the device switches off automatically.
ð
The fan keeps running for approx. 3 minutes to
dissipate the residual heat from the heating elements.
2. Switch the device off afterwards by turning the main
switch to 0 position.
Shutdown
Warning of electrical voltage
Do not touch the mains plug with wet or damp hands.
1. Proceed as described in the Switch-off section.
2. Hold onto the mains plug while pulling the it out of the
mains socket.
3. Clean the device according to the Maintenance chapter.
4. Store the device according to the Storage chapter.
Available accessories
Warning
Only use accessories and additional equipment
specified in the instructions.
Using insertion tools or accessories other than those
specified in the instructions may cause a risk of injury.
Warning
In order to prevent a potential fire hazard, only use the
original Trotec
heat-resistant H14 HEPA filter .
Designation Article number
DualHeat blowing-out tower 6.100.007.060
Attachment hood for hose
connection 6.100.007.061
Heat-resistant H14 HEPA filter 7.160.000.106
Hygrostat HG 125 6.100.002.042
Prefilter ePM 10 85 % (F7) 6.100.007.062
Prefilter COARSE 75 % (G4) 7.160.000.457
Filter insert for HEPA filter H14 6.100.007.074
Power distributor PV30 32A on
2 x 16A 6.100.002.081