Trotec TAC XT 18, Original Instructions Manual

Page: 16 / 59

16 EN vertical heater TAC XT 18 / TAC XT 27
3. Press the Room temperature button on the HEPA filter
operation setpoint screen.
4. Press the °C-specification button next to the room
temperature button to alter the room temperature on the
next screen via the arrow buttons.
5. Press the °C-specification button next to the blow-out
temperature button to alter the blow-out temperature on
the next screen via the arrow buttons.
6. Press the °C-specification button to alter the air volume
flow on the next screen via the arrow buttons.
7. Press the Configuration button on the HEPA filter operation
setpoint screen to save the settings.
8. Press the Back button to return to the HEPA filter operation
configuration screen.
9. Press the Timer mode button.
10. Press the Off or On button on the Timer mode screen to
deactivate or activate the timer.
ð
When the On button is activated, the timer starts
running once the device is switched on. When the set
time has elapsed, the device switches off. Press the
Min
specification button to alter the operating time on the
next screen via the arrow buttons. Press the Back
button twice to return to the HEPA filter operation
configuration screen.
ð
If the Off button is activated, the settings are
deactivated. Press the Back button to return to the HEPA
filter operation configuration screen.
11. Press the Heating button.
12. Press the Room or Supply air button in the Heating screen.
ð
If the Room button is activated, you can alter the room
temperature. Press the °C specification button to set the
temperature via the arrow buttons. The room
temperature is controlled automatically.
ð
If the Supply air button is activated, you can alter the
supply air temperature (temperature of the blown-out
air). Press the
°C specification button to set the
temperature via the arrow buttons. The supply air
temperature is maintained at a constant level.
13. Press the Back button twice to return to the HEPA filter
operation configuration screen.
14. Press the Regenerate filter button.
ð
The following display opens.
Back
Filter regeneration
pre Interval post
Off Off Off
ð
The enabled buttons are shown in black.
15. Press one or several buttons to activate filter regeneration
as follows.
ð
pre: filter regeneration is carried out before air cleaning
operation.
ð
interval: filter regeneration is always carried out after a
certain air cleaning operating time. If this function is
activated, the set time will be shown on the screen.
ð
post: filter regeneration is carried out after air cleaning
operation.
Back
Filter regeneration
pre Interval post
Off Off Off
240 Min
Info
Combinations of all three settings are possible, as
shown on the screen below.
16. If Interval is selected, press the displayed time to adjust
the time using the arrow buttons or by entering it directly.
ð
During the regeneration process, the filter will be heated
to 100 °C; the interval is 30 minutes.
ð
The warning light (12) is illuminated in blue during
filter regeneration.
Warning
Do not switch off the device during filter regeneration!
17. Press the Minutes specification button to alter the minute
specification setpoint on the next screen.
18. Press the Back button twice to return to the HEPA filter
operation configuration screen.
19. Press the Supply air limitation button.
ð
The supply air temperature limitation is activated once
room temperature control has been selected.
20. Press the Min or Max button on the supply air limitation
screen.
21. Press the °C specification button to set the temperature on
the next screen via the arrow buttons.
22. Press the Back button twice to return to the HEPA filter
operation configuration screen.
23. Press the Setpoints button.