EN
11
high-performance air purifier TAC ECO II
Filter change
Warning
Use an FFP2 mask and disposable gloves when
changing the filter.
The filter change intervals depend on the degree of air pollution
and the filter quality. Dirty filters impair the performance ability
of the device.
Please proceed as follows to change the H14 HEPA filter:
1. Using a screwdriver, remove the protective caps of
the 4 screws from the top of the device.
2. Remove all 4 screws.
3. Remove both hold-down devices.
4. Take off the discharge hood (1) from the device and
carefully put the discharge hood aside.
5. Remove the H14 HEPA filter (7) from the device.
6. Put the worn H14 HEPA filter in a bag and dispose of it in
the household waste.
7. Thoroughly clean the housing from the inside and outside
(see Cleaning the housing).
8. Install a new HEPA air filter.
9. Put the discharge hood (1) back on the device.
10. Fasten the discharge hood in place using the screws and
the hold-down devices.
11. Put the protective caps back on the screws.