12
EN
insulation drying unit Qube+
Key lock
To prevent an accidental maladjustment of the device settings,
the device is fitted with a key lock function.
Simultaneously press and hold the plus (38) and minus (37)
buttons for approx. 5 s to enable or disable the key lock. Pay
attention to the indication on the display.
The key lock indication in the top right corner of the LC display
changes according to the selected setting:
•
Padlock closed: The key lock is activated.
•
Padlock open: The key lock is deactivated.
Example for an enabled key lock function:
Example for a disabled key lock function:
Info
The key lock will be activated automatically after
approx. 10 min of non-use.
Displaying the operating hours
Pressing the operating hours button (39) while the device is
switched on allows you to see the number of operating hours.
The energy consumption can be read at the rear of the Qube+.
The counter has an MID certificate qualifying it for billing
purposes.
In accordance with calibration regulations, restoration
companies are so-called "meter users" or "users of
measurement readings", which binds them to observe the
German Weights and Measures Act (MessEG). The MessEG
regulates the recording and transfer of measurement readings
based on which the power consumption costs of the devices
shall be determined.
Info
If a load is connected to the service socket, its energy
consumption will also be measured by the energy
meter.
Connecting the DA 4 (external control unit)
The communication port (41) is used for data transfer to the
DA 4 control unit. The data may then be forwarded (USB and
modem or USB only).
Additionally, the internal sensor of the DA 4 must be connected
via the sensor connection (12).
Emptying the tank
Info
The drain hose must be connected and guided to an
appropriate drain or collection container.
Filling level sensors inside the tank control the automatic
operation of the pump. Once a certain filling level is reached in
the tank, the pump will start to operate automatically:
•
The message
abpumpen...
appears on the LC display.
•
The pump drains the accumulated water via the connected
drain hose.
•
If the pump cannot drain the water fast enough, the
motor’s fan will be switched off. The message
Behaelter
voll!
appears on the LC display. The maximum tank filling
level has been reached. The pump drains the accumulated
water.
•
Once the tank has been emptied, the fan motor will switch
back on and the drying operation will continue.
Shutdown
Warning of electrical voltage
Do not touch the mains plug with wet or damp hands.
•
Remove the residual water by pressing the button for
residual water draining (10).
•
Press the power button (42) to switch the device off.
•
Wait until the motor has come to a standstill.
•
Remove any hose connections.
•
Reinsert the sealing plugs removed during start-up.
