EN
11
insulation drying unit Qube+
Operation
Operating elements
36
37
38
40
39
14
42
41
12
No.
Designation
12
DA 4 sensor connection
14
Touchscreen control panel
36
LC display
37
Minus button (decrease power stage)
38
Plus button (increase power stage)
39
Operating hours button
40
Whisper mode button
41
Communication port
42
Power button
Setting the power stages and operating modes
The device comes with 4 power stages, a boost mode, a
whisper mode and the TTKwic mode.
Whisper mode can be activated by pressing the whisper mode
button (40).
Setting the power stages and the boost mode
In boost mode, the motor runs at its maximum performance.
Choose from the power stages 1 to 4 or boost mode by pressing
the buttons plus (38) or minus (37).
Setting whisper mode
In whisper mode, the compressor runs with a max. motor power
of 60 %, thus reducing the noise emission (e.g. at night).
Whisper mode is automatically left after 10 h and the
compressor starts to run at its previously chosen power stage
again. Selecting another stage via the control panel will also
stop the whisper mode.
Press the whisper mode button (40) to activate or deactivate
whisper mode.
•
A countdown (10 h) on the control panel indicates the
remaining whisper mode duration.
•
Pressing a button on the control panel deactivates whisper
mode. This only applies if the key lock is disabled.
Setting TTKwic mode
In this operating mode the device's motor is turned off and only
the pump operates. So if a dehumidifier transports water into
the device by means of a condensate pump, the accumulated
water will be pumped off when the tank's maximum filling level
is reached.
Press the whisper mode button (40) followed by minus (37) to
activate or deactivate TTKwic mode.
Info
In whisper mode you can enable or disable TTKwic
mode at any time.
The whisper mode duration (10 h) also applies to the
TTKwic mode.