EN
19
cordless grinder PMTS 01-12V
Operating mode: Drilling
For drilling holes (1 mm to 3.2 mm) into metal, wood or plastics:
•
use the HSS twist drill bits (
12
)
Further accessories for any other applications
Note that the maximum diameter of
combined abrasive
accessories
, as well as
abrasive cones and abrasive pencils
must not exceed 55 mm, and that the maximum diameter of
sandpaper sanding accessories must not exceed 80 mm.
Shutdown
Warning of electrical voltage
Do not touch the mains plug with wet or damp hands.
•
Switch off the device.
•
Hold onto the mains plug while pulling the power cable of
the charger out of the mains socket.
•
If required, allow the device to cool down.
•
Remove the battery from the device (see Start-up chapter).
•
Remove the tool from the device (see Start-up chapter).
•
Clean the device according to the Maintenance chapter.
•
Store the device according to the Transport and storage
chapter.
Available accessories
Warning
Only use accessories and additional equipment
specified in the instructions.
Using insertion tools or accessories other than those
specified in the instructions may cause a risk of injury.
Designation
Article number
Spare battery 12V / DC 2.0 Ah
6.200.000.102
Charger PMTS 01-12V AC
7.430.001.267
Cordless grinder accessories set
282-piece
6.210.000.301
Errors and faults
The device has been checked for proper functioning several
times during production. If malfunctions occur nonetheless,
check the device according to the following list.
Troubleshooting tasks which require the housing to be opened
must only be carried out by an authorized specialist electrical
company or by Trotec.
Light smoke or odour is emitted during the first use:
•
This is not a fault. These phenomena disappear after a
brief runtime.
The battery does not charge:
•
Check whether the battery is inserted correctly in the quick
charger.
Slide the battery into the quick charger in a way that the
battery terminals engage in the quick charger. The battery
must lock in place in the quick charger.
•
Check the power connection.
•
Check the power cable and mains plug for damage.
•
Check the on-site fusing.
•
Check the quick charger for damage. If the quick charger
is damaged, stop using it. Contact the Trotec customer
service.
•
Check the battery terminals for dirt. Remove any dirt.
•
The battery might be defective and have to be replaced.
Only use batteries of the same type.
The device does not start:
•
The battery power might be too low. Recharge the battery.
•
Check whether the battery is correctly connected to the
device.
Slide the battery onto the device in a way that the battery
terminals engage. The battery must lock in place in the
device.
•
Check the battery terminals for dirt. Remove any dirt.
Info
Wait for at least 10 minutes before switching the
device back on.
