12
EN
cordless grinder PMTS 01-12V
Storage
Before
storing the device, observe the following:
•
Switch off the device.
•
Hold onto the mains plug while pulling the power cable of
the charger out of the mains socket.
•
Remove the tool from the tool holder.
•
Allow the device to cool down.
•
Remove the battery from the device.
•
Clean the device as described in the Maintenance chapter.
•
Do not store Li-ion batteries which are completely
discharged. Storing discharged batteries can lead to a
deep discharge and thus damage the battery.
When the device is not being used, observe the following
storage conditions:
•
dry and protected from frost and heat
•
Ambient temperature below 45 °C
•
Protected from dust and direct sunlight
•
Store the insert tools and other accessories in the storage
box.
Start-up
Unpacking the device
•
Take the device and the accessories out of the packaging.
Warning of electrical voltage
Electric shock from insufficient insulation.
Check the device for damages and proper functioning
before each use.
If you notice damages, no longer use the device.
Do not use the device when the device or your hands
are damp or wet!
•
Check the contents for completeness and look for
damages.
Warning
Risk of suffocation!
Do not leave the packaging lying around. Children may
use it as a dangerous toy.
•
Dispose of the packaging material according to the
national regulations.
Charging the battery
Note
The battery can be damaged in case of improper
charging.
Remove the charger's mains plug before inserting or
removing the battery.
Never charge the battery at ambient temperatures
below 10 °C or above 40 °C.
The battery is partially charged upon delivery to avoid damage
to the battery caused by a deep discharge.
The battery should be charged prior to initial start-up and when
the battery is low (the LED of the battery level indication (
20
) is
illuminated in red). To do so, please proceed as follows:
1. Slide the battery (
5
) onto the quick charger (
6
) as depicted
until the battery locks in place.
5 h
20
21
5
6
4
2. Insert the mains plug of the quick charger (
6
) into a
properly fused mains socket.
ð
The battery LED (
20
) is illuminated in red.
ð
Charging requires approx. five hours.
3. Wait until the red battery LED (
20
) goes off and the green
battery LED (
20
) lights up.
ð
The battery (
5
) is fully charged.
4. Hold onto the mains plug (
21
) while pulling the power
cable of the quick charger (
6
) out of the mains socket.
ð
The battery (
5
) and the quick charger (
6
) may have
become warm during charging.
Allow the battery (
5
) to cool down to room temperature.
5. Take the battery (
5
) out of the quick charger (
6
) by
pressing and holding the release button (
4
) and pulling the
battery (
5
) off the quick charger (
6
).
