EN
37
850W pendulum action jigsaw PJSS 10-230V
Mounting the rip fence
The rip fence can be fastened on both sides of the
device.
1.
Loosen the locking screws (
15
) at the slot.
Make sure not to unscrew the locking screws
completely.
8
15
2.
Slide the rip fence (
8
) into the slot with the
marking pointing up.
3.
Move the rip fence (
8
) into the desired
position.
4.
Tighten the locking screws (
15
).
Selecting the stroke rate
The required stroke rate depends on the material
and the operating conditions and can be determined
by way of field-testing.
The setting range covers the levels 1 – 6
(0 – 3,000 rpm). You can change the preselected
stroke rate level at any time.
1.
Turn the setting wheel (
1
) to the desired
stroke rate level.
1
Adjusting the pendulum action
You can adjust the pendulum movement of the saw
blade. Levels 1 to 3 allows for a faster work
progress and level 0 (pendulum movement off)
enables fine and clean cutting edges.
The ideal pendulum level for the respective
application can be determined by way of field-
testing. Please observe the following instructions:
•
If you want to obtain a fine and clean cutting
edge, preferably select a low pendulum level
or switch off the pendulum action completely.
•
Switch off the pendulum action when
processing thin materials.
•
Work at a low pendulum level when
processing hard materials.
•
For soft materials or when sawing wood with
the grain you can work with the maximum
pendulum level.
Summary of Contents for PJSS 10-230V
Page 67: ......
