EN
10
Operating manual – Impact drill PHDS 10-230V
Inserting and using the depth stop (optional)
With the depth stop you can determine the penetration depth of
the drill bits.
Info
When using wall plugs, pay attention to the precise
drilling depth. If the drilled hole is too deep, the wall
plug will slide too far into the wall or workpiece. If the
hole is too small, the wall plug will protrude.
1. Loosen the screw connection of the additional handle (8)
by rotating the gripping surface to the left.
2. Insert the depth stop (6). When doing so, make sure that
the notches of the depth stop point to the device.
8
6
3. Adjust the depth stop to the desired length.
4. Tighten the screw connection of the additional handle (8)
by rotating the gripping surface to the right.
5. Check the additional handle (8) for tight fit. If necessary,
tighten the additional handle further.
X
Connecting the power cable
1. Insert the mains plug into a properly secured mains
socket.
