15
EN
Operating manual – portable circular saw PCSS 10-1400
Mounting and adjusting the rip fence
1. Loosen the wing screw (4) and insert the rip fence (12) into
the rip fence holder (6).
4
12
6
2. Set the desired distance from the cutting line to the edge
of the workpiece (cutting width) using the scale on the rip
fence (12) and the arrow (32) on the base plate.
The figure below shows a 4 cm setting by way of example:
4
cm
32
12
3. Retighten the wing screw (4).
Adjusting the speed
You can adjust the speed at any time. Level 1 corresponds to a
low speed and level 6 to a high speed.
1. Turn the setting wheel (24) to the desired level.
24
As an orientation for selecting the speed level, you can use the
table below, which contains non-binding recommendations:
Material
Recommended level
Acrylic glass plates, Plexiglas
2 to 4
Aluminium plates
4 to 6
Aluminium profiles
4 to 6
Coated and veneered plates
6
Plasterboards
1 to 2
PVC plates
3 to 5
Hardwood and softwood (solid wood)
for cross and longitudinal cuts
6
Chipboards, hardboards
6
Mineral wool boards
1 to 2
Blockboards, plywood
6
Cement-bonded particle boards
1 to 2
