12
EN
infrared radiant oil heater IRO 15
The flame goes out during combustion:
•
Make sure the air supply is unobstructed. If required, clean
the air intake opening.
•
Check the filling level of the tank. Refill with fuel if the tank
is empty (see chapter Operation).
•
Check the fuel filter in the fuel pump for dirt. If it is dirty,
please contact the customer service.
•
Check the fuel for contaminations and replace it if
required.
•
Power failure: In the event of a power failure the ignition is
extinguished, the device switches off immediately. After a
power failure the device will not restart automatically, it
has to be started via the on/off switch.
There is a fuel leak:
•
Check whether too much fuel was filled in. Drain the fuel if
necessary, see chapter Draining the tank.
•
Check the drain screw for tight fit and retighten it if
necessary.
•
Check the sealing at the drain screw and replace it if
damaged.
•
Check the fuel pump for leaks. If there are doubts about
the proper condition of the fuel pump, please contact the
customer service.
The device emits smoke or dust:
•
Check the mains voltage.
•
Check the fuel for contaminations and replace it if
required.
•
Check the tank for contaminations and drain it if required
(see chapter Maintenance). Refill with clean fuel.
The flame emerges from the air outlet:
•
Check the mains voltage.
•
Check the fuel for contaminations and replace it if
required.
•
Check the tank for contaminations and drain it if required
(see chapter Maintenance). Refill with clean fuel.
Note
Wait for at least 3 minutes after maintenance and
repair work. Only then switch the device back on.
Your device still does not operate correctly after these
checks?
Please contact the customer service. If necessary, bring the
device to an authorised specialist electrical company or to
Trotec for repair.
