Chapter 1
Tropos 7320 Router Installation Guide
12
Mount the router on a metal pole
1.
Select a mounting location. You can attach the router to any pipe or pole with diameter
between 1 inch and 10 inches.
2.
Slip the flat portion of the hose clamps under the inner tabs or slots of the pole bracket.
3.
Use the hose clamps to attach the pole bracket to the pole. Depending upon the diameter of
the pole, you may need to use a single small clamp, single large clamp, or pair of large
clamps joined together to reach around the pole.
4.
Attach the sun shield of the router to the pole bracket with three 5/16-inch machine screws.
Insert one screw through the hole in the center back of the sun shield and the other two
screws through the curved slot tracks.
shows the proper screw locations on the back
of the sun shield.
Note
Use anti-seize lubricant, such as Loctite 37230, when screwing the router into the sun shield.
5.
Level the sun shield by rotating the unit along the curved slot tracks. A built-in level is
located on the left side of the shield. Tighten the screws.
6.
Slide the router into place with the antennas on top and secure it at the end with four #10-32
hex head machine screws.
To continue installing the router, see
“Connecting Cable Attached Antennas”
FIGURE 5
Sun Shield Connections
trp_154
Bubble
level
Screws to attach router to sun shield
Use machine screws
to attach sun shield
to pole bracket
