22
Auto leveling
：
①
Automatic leveling for automatic leveling version of the machine, the manual
version can not be use. Click the leveling function in the figure to
automatically pop up the interface, select "automatic leveling",jump out of
the figure (1) interface, and start leveling. After the Detection is completed,
the error value of each point will be displayed. If the value is greater than 0.5,
adjust the leveling nut in the corresponding area, and then reset until all
values are less than 0.5, then the automatic leveling is completed
②
Then click “Z offset”, the print head will move to the middle of the platform,
observe the height of the nozzle and platform, and then click
①②，
make
the distance between the nozzle and platform for a piece of A4 paper height,
then click
③
, reset the zero, so that the end of leveling.
Figure
（
1
）
autolevel
③
①
②
Precautions:
Before each zeroing or automatic leveling, the Z axis must be lowered to the
position below the photoelectric sensor switch, as shown in the figure below
Photoelectric
sensor switch
Double limit
plate
The board is
in the switch
sensing area
Summary of Contents for X5SA-500-2E
Page 1: ......
Page 28: ...2 How to use slice software Type setting follow the steps below to complete the setting 24 ...
Page 32: ......
