Assembly material specification and quantity
：
basic frame 1pcs
Aluminum6
20*20*654
1pcs
Print head parts
1pcs
drag chain plate
1pcs
screws
M4*20 6PCS
Step 3: Sliding plate assembly
1
pulley
Aluminum6
M4 screws holes positioning
print head
2-M4*20
2-M4*20
2
2
3
4
6
1.Insert the print head into the
Aluminum6
, pay attention to the direction of the M4 screw hole, as
shown in Figure 1.
2. Insert the
Aluminum6
into the alignment hole of the chassis, and tighten the screw
RM4*20 without locking it, as shown in Figure 2.
3. Move the left and right sliders to confirm that the
Aluminum6
moves flexibly after locking
the RM4*20 screw.
4. After adjustment, lock the screw of RM5*25 on the Y-axis guide and move the
Aluminum6
again. Repeat the adjustment to ensure that the slide is flexible and has no gap after the locking screw.
As shown in the figure, the pulley on the print head
runs through the
Aluminum6
and the slide block
moves smoothly without any clearance
The skateboard is in line with
the
Aluminum6
Summary of Contents for X5SA-500-2E
Page 1: ......
Page 28: ...2 How to use slice software Type setting follow the steps below to complete the setting 24 ...
Page 32: ......
