TRONXY X5SA-500-2E, User Manual

Page: 17 / 32

Assemble material specification and quantity：
mainframe 1pcs
Hot bed (with drag
chain)500*500*3 1pcs
beam 2pcs
boat nuts
2pcs
plastic
nuts M3
6pcs
screws
PM4*8
2pcs
spring 6pcs
nuts M3
8pcs
screws KM3*35 6pcs
screws
PM4*12
8pcs
Double
limit
plate 2pcs
1. Take the hot bed, pass through the hot bed with 6 KM3*35 screws,
and lock it with M3 nut, as shown in the figure;Insert the spring
into the screw of KM3*35, extend from the hole corresponding to the
beam, and screw into the plastic nut of M3 to adjust the spacing
between the hot bed and the beam by about 10mm.The relation between
beam position and wire is shown below. 2. Turn the two screw rods to make the left and right side plates on
the same plane and fasten the hot bed components to the side plates
with 8 PM4*12 screws, as shown in the figure. The drag chain bracket
is close to the side of the feeding motor component.Rotate the screw
rod in the same direction to make the platform move up and down
synchronously, and make sure the movement is flexible. Otherwise,
loosen the screw PM4*12 and adjust the screw at the both end of the
polished rod.
Step 9: print platform assembly
12