Trojan TOUR 370, Instruction And Assembly Manual

Page: 9 / 26

10267 - 9
4. ASSEMBLY STEPS (CONT.)
STEP 3: HANDLEBAR AND
COMPUTER ASSEMBLY
• Attach the Handlebar (6) to the Front Post (4)
and secure with two Allen Bolts (22) and two
Curved Washers (23).
• Remove the Grommet (24) from the Front Post
(4), insert the Lower Pulse Wires (36) through
the hole on Front Post (4) and pull them out of
the top side of the Front Post (4). Now connect
them to the Upper Pulse Wire (27).
• Connect the Middle Computer Wire (21) to
the Upper Computer Wire (26). Slide the
Computer (8) onto the Front Post (4) and
secure with four Screws (25) which are
pre-assembled on the back of Computer (8).
STEP 4: SEAT AND SEAT POST
ASSEMBLY
• Attach Seat (7) to the Seat Post (5) and secure
with three Flat Washers (33), three Spring
Washers (34) and three Nylon Locknuts (35)
which are pre-assembled on the bottom of
Seat (7).
• Insert the Seat Post Assembly (5) through the
Cover (12) of the Seat Post into the Main Frame
(1). Secure in position using the Quick Release
Knob (19). Move the Cover (12) down into
position.
CAUTION:
Ensure that cables are not damaged
during assembly or when tightening screws.