5
3.
Fit the legs onto the frame ensuring that the leg with the wheels is fitted to the front and the leg
without wheels is fitted to the back. Make sure that the wheels are facing towards the front and
that the feet are facing downwards. Insert the M10 bolts provided facing downwards ensuring
that you have a washer above and below the leg. Fit the M10 Nut and tighten securely.
Note: If you are having difficulties threading the nut onto the bolt, with assistance prop up the
base leg and the frame on wooden blocks to gain easier access to the nut underneath.
4.
Adjust the 4 leveller feet to ensure that each corner is fully supported on the floor. Once
adjusted, lock the position by tightening the lock wing nut inside the leveller feet.
5.
Slide the seat post into the seat tube at the rear of the frame and tighten the adjustable quick
release knob until you are ready to set the height position. Slide the seat assembly onto the seat
post and fit the quick release handle provided from the bottom upwards. Fit the thumbscrew at
the top of the quick release bolt to secure until you are ready to set the fore/aft position.
Seat Fore/Aft Adjust Lever
Seat Height Adjuster Knob
6.
To fit the X-Bars™ Handlebar System Head unit, you must first fit the adaptor. Remove the
bottom cover by undoing the 2 M4 Hex head screw. This will give access to the main X-Bars
frame internally. The adaptor should be fitted so that the head post is facing downwards and
towards the rear of the assembly.
Insert the 4 x M8 bolts provided with the adaptor towards the rear, and ensure that the washer is
placed behind the M8 Nut and tighten securely. Refit the bottom cover.
7.
The X-Bars System assembly is inserted into the head tube with the head of the assembly facing
towards the front of the bike. Tighten the adjustable quick release knob until you are ready to set
the head height position.
Note the orientation of the
Handlebar and Bar Ends.
Height Adjuster Knob
