Thermostatic electric shower
2
Temperature/flow rate
The temperature control on the unit can be
adjusted to provide shower temperatures
nominally between 35°C and 47°C. The unit
will give higher and lower temperatures if given
extreme supply conditions.
Note:
The maximum flow rate for the given
temperature will be greater in the summer
than in winter because of ambient temperature
variance of the mains water supply.
It is strongly advised to select economy power
during periods of hot weather, otherwise at all
other times, leave the power setting at full to
provide the maximum flow rate.
Safety cut-out
The unit is fitted with a non-resettable over-
temperature safety device. In the event of
abnormal operation which could cause unsafe
temperatures within the unit, the device will
disconnect the heating elements. It will require a
visit from a qualified engineer to determine the
nature of the fault and replace the safety device,
once the unit has been repaired.
This book contains all the necessary installation
and operating instructions for your thermostatic
electric shower.
Take time to read this book thoroughly and
familiarise yourself with all instructions before
installation. Please keep it for future reference.
The shower installation must be carried out by a
suitably qualified person and in the sequence of
this instruction book.
Care taken during the installation will provide a
long, trouble-free life from your shower.
SPECIFICATIONS
Electrical
Nominal power
Nominal power
rating at 240V
rating at 230V
8.5kW – (40A MCB rating) 7.8kW – (40A MCB rating)
9.5kW – (40A MCB rating) 8.7kW – (40A MCB rating)
10.5kW–(45A MCB rating) 9.6kW – (45A MCB rating)
Water
Inlet connection – 15 mm diameter.
Outlet connection – ½” BSP male thread.
Entry Points
Water –
Right:
middle back, bottom, top.
Cable –
Right:
middle back, bottom, top.
Materials
Backplate, cover, controls, showerhead – ABS.
Sprayplate – Acetal.
Elements – Minerally insulated corrosion resistant
metal sheathing.
Dimensions
Height – 335 mm
Width – 225 mm
Depth – 95 mm
Standards and Approvals
Waterproof rating IPX4.
Complies with the requirements of current British
and European safety standards for household
and similar electrical appliances.
Complies with requirements of the British
Electrotechnical Approvals Board (BEAB).
Meets with Compliance with European
Community Directives (CE).
ImpoRtaNt:
When first installed the unit
will be empty. It is essential the unit
should contain water before the elements
are switched on. As this unit has electronic
control, it is vital that the commissioning
procedure is followed. Failure to carry out
this operation will result in damage to the
unit and will invalidate the guarantee.
Replacement parts can be ordered from Customer
Service. See
‘spare parts’
for details and part numbers.
INTRODUCTION
UNDERSTANDING YOUR SHOWER
