Thermostatic electric shower
9
Note:
The control knob is an integral part of the
cover – DO NOT attempt to remove it.
unscrew the two top and one bottom retaining
screws. There is no need to completely remove
the screws, just enough to lift the cover from the
backplate. To allow access to the pipe and cable
connections remove the trimplate by lifting away
from the backplate.
Entry positions for the mains water are from the
top, bottom or back. Cable entry is via the top,
bottom or back.
Note:
Deviations from the designated entry
points will invalidate product approvals.
If bottom surface entry is required, then the
necessary hole will need to be cut out in the
‘thinned section’ of the trimplate using a junior
hacksaw and file
(fig.8)
.
If bottom or rear entry is chosen, the pipe trim
will need to be fitted in the top entry position on
the backplate
(fig.9)
.
If installing a supply pipe from the rear or
bottom, the centre of the inlet valve to the wall
surface is 21 mm
(fig.10)
.
Note:
If entry is from the rear, the nut of the
compression fitting will be partially behind the
surface of the wall. This area MuST be left clear
when plastering over the pipework in order to
make the nut accessible for future adjustments.
After choosing the site for the shower, use the
backplate as a template and mark the three wall
fixing holes
(fig.11)
.
Drill and plug the wall.
(An appropriate drill bit should be used. If the
wall is brick, plasterboard or a soft building block,
appropriate wall plugs and screws should be fitted).
Screw the top left-hand fixing screw into
position leaving the base of the screw head
protruding 6 mm out from the wall.
Hook the backplate over this screw, then fit the
other two fixing screws into position.
Do not fully tighten the screws at this stage,
as the fixing holes are elongated to allow for
out of square adjustment after the plumbing
connections have been completed.
21mm
Fig.10
Fig.11
FITTING THE SHOWER TO THE WALL
FITTING THE SHOWER TO THE WALL
