Thermostatic electric shower
16
To adjust the shower temperature
The showering temperature is varied by turning
the temperature control which changes the
mix of hot water coming from the heater can
and the incoming cold water. On the display
circumference are eleven outer segments which
represent the total angular movement of the
temperature control. Rotating the temperature
control causes inner segments to fill, indicating
the actual position of the control relative to its
minimum and maximum limits.
Minimum temperature
(fig.26)
position (one
inner segment full that corresponds to the
control position).
Maximum temperature
(fig.27)
position (all
inner segments full that corresponds to the
control position).
To decrease the shower temperature
Turn the temperature control anti-clockwise; the
current temperature display is replaced by two
flashing ‘down arrows‘
(fig.28)
. Five seconds
later the display shows the revised temperature.
To increase the shower temperature
Turn the temperature control clockwise; the
current temperature display is replaced by two
flashing ‘up arrows‘
(fig.29)
. A few seconds
later the display shows the revised temperature.
Note:
It is advisable to be certain that the
showering temperature is satisfactory by testing
with your hand before stepping under the
showerhead.
There will always be a time delay of a few
seconds between selecting a temperature
and the water reaching the stable selected
temperature.
Fig.26
Fig.27
Fig.28
Fig.29
