11
To adjust the shower temperature -
Economy and High settings only
• The water temperature is altered by increasing
or decreasing the flow rate of the water
through the shower via the temperature
control
(fig.6).
• After obtaining your showering temperature,
the knob can be left as the normal setting
and should only need altering to compensate
for seasonal changes in ambient water
temperature.
NOTE:
The preferred knob position on ECONOMY
will give a different temperature to the same
position on HIGH.
To decrease the shower temperature
• Turning the temperature control
anti-
clockwise
will increase the flow of incoming
water through the shower and make the
showering water
colder
.
To increase the shower temperature
• Turning the temperature control
clockwise
will decrease the flow of incoming water
through the shower and make the showering
water
hotter
.
NOTE:
It is advisable that the showering
temperature is satisfactory by testing with your
hand before stepping under the showerhead.
There will always be a time delay of a few
seconds between selecting a flow rate and the
water reaching the stable temperature for that
flow rate.
USER OPERATING INSTRUCTIONS
OPERATING FUNCTIONS
TP – Temperature Protection
During normal operation if the temperature
exceeds the showering safety limit the power
to the elements will be removed completely,
although water will continue to flow. When the
temperature has cooled sufficiently, power to the
elements will be automatically restored to the
settings at the time of interruption.
Abnormal Safety cut-out
The unit is fitted with a non-resettable thermal
cut-out safety device. In the event of abnormal
operation which could cause unsafe
temperatures within the unit, the device will
disconnect the heating elements. It will require a
visit from a qualified engineer to determine the
nature of the fault and replace the safety device
once the unit has been repaired.
Two Stage Pressure Switch
This unit is fitted with a two stage pressure
switch. In normal operation, 1 Bar running
inlet pressure is required to enable the shower
to operate at full power (1.5 Bar running inlet
pressure required for 10.5kW unit). In the event
a low pressure condition (down to 0.7 Bar), the
shower will continue to operate at a reduced
power setting (1.2 Bar required for 10.5kW unit).
Below 0.7 bar pressure, all power to the elements
will be removed. Power to the elements will be
restored once the minimum appropriate inlet
pressure is re-established.
IMPORTANT - CLEANING
It is recommended that all products
are cleaned using warm, soapy water.
DO NOT
use abrasive or aggressive
chemical cleaning products as this may
affect the product surface finish and
invalidate your guarantee.
