T300si electric shower
mounting bracket
(fig.)
and slide down into
place, making sure the control cable does not
get trapped.
Secure in place with the single screw at the
bottom of the control panel
(fig.)
.
note:
To remove the panel once fitted, remove
the single retaining screw, and lift off from the
wall bracket lugs.
Fig.
Fig.
Control
cable
clamp
Fig.0
Fitting the control panel
FITTING THE CONTROL PANEL
Refit the trimplate and secure with the two
screws.
Before replacing the cover, check on the PCB
that the purge pin is located on its two pins
– the factory set position, see
(fig.)
.
Locate the tags on the cover into the holes on
the backplate and guide into position. Secure
the cover in position with the three retaining
screws.
note:
DO NOT fully tighten at this stage as the
remote pack cover is fitted temporarily in order
to carry out the commissioning procedure.
Fitting the remote pack cover
FITTING THE REMOTE PACK COVER
W-020-A
WARNING!
This appliance is not intended for use
by young children or infirm persons
unless they have been adequately
supervised by a responsible person to
ensure that they can use the appliance
safely.
Young children should be supervised to
ensure that they do not play with the
appliance.
Summary of Contents for T300si
Page 31: ...T300si electric shower 29...
