T300si electric shower
9
T00137
ImporTAnT:
the remote pack must be
mounted on a flat surface which covers
the full width and length of the backplate.
It is important that the wall surface is flat
otherwise difficulty may be encountered
when fitting the cover and subsequent
operation of the unit may be impaired.
The remote pack must always be positioned
so that there is easy access for installation and
maintenance. Where this is difficult or a suitable
wall is not available, a mounting bracket similar
to that shown in
(fig.9)
can be used.
Position the remote pack in a dry area, ideally in a
linen or airing cupboard. It must be well ventilated
and not covered with towels, sheets, etc.
ImporTAnT:
the remote pack MUSt be
mounted vertically. Do Not MoUNt It
horIzoNtally.
Loft installation notes
If the remote pack is installed in a loft area the
following requirements must be met for future
servicing purposes:
a.
There must be no risk of the remote pack,
heated water pipe or PRD tube becoming
frozen.
b.
The remote pack must not be covered with
any form of insulating material that may give
rise to electrical circuits overheating during
periods of high ambient temperature.
c.
A safe means of access must be provided into
the loft, e.g. via a fixed loft ladder.
d.
The remote pack must be installed upright
and in an accessible and safe location.
e.
Ceiling joists must be adequately boarded to
provide safe and unobstructed access to, from
and around the remote pack.
f.
There must be adequate lighting in the loft
for servicing purposes.
Procedure
Unscrew the top and bottom retaining screws
(fig.0)
and lift cover from the backplate. To
allow access to the pipe and cable connections,
remove the two screws
(fig.)
and take off the
trimplate.
Fig.0
Fig.
Fig.
Fitting the remote pack
FITTING THE REMOTE PACK
Summary of Contents for T300si
Page 31: ...T300si electric shower 29...
