4
ADVICE TO USERS
The following information will help you
understand how the handwash product
operates.
The electric heating elements operate at
a constant rate. It is the flow rate of the
water passing through the heater can which
determines the water temperature at any given
setting. The slower the flow, the hotter the water
becomes and the faster the flow, the cooler the
water.
During winter the mains water supply will be
cooler than in summer, therefore, the water
temperature of the handwash unit will vary
between seasons on any one setting of the
temperature control. To alter the temperature,
simply adjust the control knob to the desired
temperature. The stabiliser valve minimises
variations in water temperature during mains
water pressure changes. If changes in water
temperature are experienced during normal
use, it will most likely be caused by the water
pressure falling near to or below the minimum
level. The drop in pressure may be due to water
being drawn off at other points whilst the unit
is in use. If the pressure drops appreciably
below the minimum, the heating elements will
automatically cut out.
DO NOT place items such as soap or shampoo
bottles on top of the unit. Liquid could seep
through the joint between the cover and back
plate and possibly damage the sealing rubber.
If water becomes too hot and you cannot
obtain cooler water, first check that the
sprayhead is not blocked. Secondly, leave the
product for 5 minutes and run the cycle again.
INTRODUCTION
This book contains all the necessary fitting and
operation instructions for your T30IR Instaflow
handwash. Please read carefully.
The installation must be carried out by a
suitably qualified person and in the sequence of
this instruction book.
SPECIFICATIONS
Electrical
Nominal power
Nominal power
rating at 240V
rating at 230V
3kW – 13A
2.8kW – 13A
Water
Inlet connection –
½” BSP thread
Outlet connection –
½” BSP thread
Entry Points
Water –
Right: bottom
Cable –
Right: top, bottom, or middle
back
Materials
Backplate, cover, control knobs –
ABS
Elements – Minerally insulated corrosion
resistant metal sheathing.
Dimensions without Spout
T30
IR
Height – 183mm
Width – 228mm
Depth – 82mm
Standards and Approvals
Splashproof rating
IPX4
Complies with the requirements of current
British and European safety standards for
household and similar electrical appliances.
Complies with requirements of the British
Electrotechnical Approvals Board (BEAB).
Meets with Compliance with European
Community Directives (CE).
High visibility clothing may
affect the activation range
of the infa-red handwash
sensor.
