background image

BS01981726

BS02621727

BS01981726

l. Installation Notice

1. Please lay water pipes in accordance with this manual.
2. Floor drain should be installed on the site.
3. The product should be installed only after the completion of house 
    interior decoration in case the paint or other chemicals erode the 
    mixer surface.
4. Clean pipes to get rid of mud, sand or other debris blocked in pipes 
    before installation.
5. Check whether the threads can be matched. Otherwise, installing 
    forcefully will damage the components.
6. After installation, check all the joints to make sure they are firmly 
    connected. Run the water. Turn on and off repeatedly to ensure no 
    leaking problem. After that, the product is ready for normal use.
7. Hand the manual to users.

II. Operation Notice

1. The product is used under water pressure 0.05~1.0 MPa, water 
    temperature 4~90°C.
2. Do not hang heavy things on the product.
3. Remember to turn off the mixer if no water comes out of it
    (Especially when nobody in the house or during the decoration period).
4. Clean the surface of the product regularly to keep it glossy. Note: Please
    do not use inappropriate tools such as sharp brushes, rough sponges,
    scouring pads or corrosive detergent. And it is not recommend to use the
    detergent sold in the market, because its formula changes frequently.
    Please clean the product with wet cloth and soapy water after usage.
    Then rinse the soap off with clean water and dry with a soft cotton cloth.
5. When indoor temperature drops below 0°C, take necessary measures
    (Keep the product warm, close windows) to prevent the product from
    frost cracking (Especially when windows open for air ventilation while
    nobody in the house).
6. Adjust the temperature before use to avoid scald.
7. Do not disassemble the product without help from the professionals.

lll. Installation Diagram

IV. Installation Steps

(

Fig.1-21

)

The installation diagram is only for reference. 

The product is subject to the real object.

S2.5 Wrench (supplied)

Prepare and check the 

following tools.

Spanner

Philips

Screwdriver

Protection Sheath

Stop Collar

Inlet Valve Body

Plastic Spacer

Locking Washer

Locking Nut

Remove the protection sheath 

off the two inlet valve bodies. 

Take off the stop collar and 

screw off the locking nuts to 

the bottom. 

#30304

4 Piece deck mount tub filler with hand shower

INSTALLATION GUIDE

Last revision: October 23rd

Reviews: