Setscrew
Pass the hand shower
seat downward through
the bathtub deck. Put on
the rubber washer and
locking washer. Put back
the locking nut and
tighten it with setscrew.
Balance Weight
Connect the knitted
hose to the lift rod
base. Install the
balance weight at
a proper position in
the knitted hose and
make sure the hose
could be completely
pulled out of the
hand shower seat.
Turn off the valves
and run water for
pressure test to
ensure there is no
leakage. Make sure
hot water is
connected to the left
valve body and cold
water to the right.
Cold water
Hot water
Turn on the valves
and run water for
pressure test to
ensure there is no
leakage. Then put
back the protection
sheath to the
hand shower seat .
Hex Nut
Decorating Ring (small)
Protection Sheath
Remove the protection
sheath and put on the
decorating ring. Tighten
it with the hex nut.
Handle
Screw
Spacer
Blue
Install the spacer and
then handles (attention
to the red mark on the
left and blue on the
right) and tighten the
screws on the handles.
Cap
M5 Screw
Loosen the M5 screw and
take off the cap.
Rod Cap
Body
M5 Screw
Decorating Ring (big)
Place the decorating
ring and the body onto
the lift rod base one by
one. Tighten them with
two M5 screws. Then
insert the rod cap into
the slot in the back of
the body to connect
with the lift core.
Red
