Concentric thermostatic mixer valve
15
Push into the
bulkhead outlet
The flow regulator
is only designed
to have the flow of
water entering from
the top. The top
can be identified by
the angular lip
running around it.
Fig.
Fig.5
BULKHEaD aSSEmBLY
Screw the bulkhead elbow to the bulkhead body.
Screw the completed assembly onto the
threaded connector temporarily to mark the
position of the two fixing holes for securing the
bulkhead to the wall.
Note: If screw thread protrudes too far out of the
wall, it can be cut to the correct length using a
hacksaw.
Unscrew and remove the bulkhead assembly.
Check the location of the pipe in the wall before
drilling.
Drill and plug the wall.
(An appropriate drill bit should be used. If the
wall is brick, plasterboard or a soft building block,
appropriate wall plugs and screws should be fitted).
If fitting to a hollow wall structure, it may be
preferable to secure the bulkhead by applying a
bead of silicon seal to the back of the bulkhead.
Apply PTFE tape to the threaded connector.
Screw the bulkhead assembly onto the threaded
connector until tight to the wall and the two
fixing holes are aligned. Secure to the wall
(fig.5)
.
Finish by clipping the cover onto the bulkhead,
making sure the protruding legs locate in the
bulkhead body.
Flow regulation
A flow regulator is supplied for use with high-
pressure water systems and may be fitted with
any of the systems listed to reduce flow rate and
assist economy.
To fit the flow regulator
To fit the flow regulators (flexible hose
connection) press it into the outlet of the
bulkhead, correctly, please note the flow
regulator is only designed to work in one
direction
(fig.)
.
The flow regulator for 15mm rigid pipe must be
fitted into the showerhead.
