Concentric thermostatic mixer valve
8
FIttInG tHE mIXER
Mark the position of the four locating screws
for the mounting plate, although if installing to
a solid brick wall using two diagonal holes will
usually be enough.
Drill and plug the wall.
(An appropriate drill bit should be used. If the
wall is brick, plasterboard or a soft building block,
appropriate wall plugs and screws should be fitted).
Fit the mounting plate onto the wall
(fig.9)
.
The inlet elbows allow for either rising, falling or
rear entry hot and cold water supplies. The elbows
have ‘O’ ring seals
(fig.10)
to the body and do
not require PTFE tape or other means of sealing.
ImPoRtant:
Make sure that all the supply pipework has
been flushed through before fitting the mixer
(fig.11).
O ring seal
Elbow
Fig.11
Fig.10
Fig.9
