Concentric thermostatic mixer valve
1
The controls require one hole to be cut out of the
panel or cubicle. Use the face plate as a template
to mark the hole positions then extend further to
allow access for the filters.
Route the pipework to valve position.
FIttInG tHE mIXER
Mark the position of the four locating screws
for the mounting plate, although if installing to
a solid brick wall using two diagonal holes will
usually be enough.
Drill and plug the wall.
(An appropriate drill bit should be used. If the
wall is brick, plasterboard or a soft building block,
appropriate wall plugs and screws should be fitted).
Fit the mounting plate
(fig.19)
.
The inlet elbows allow for either rising, falling
or rear entry hot and cold water supplies. The
elbows have ‘O’ ring seals (fig.6) to the body
and do not require PTFE tape or other means of
sealing.
ImPoRtant:
make sure that all supply pipework has
been flushed through before fitting the
mixer (fig.0).
Connect the hot water supply to the inlet marked
HOT, ‘H’ or red/orange label and connect the
cold water supply to the inlet marked
COLD, ‘C’ or blue label
(fig.1)
.
Tighten all compression fittings.
Tighten all the grub screws to secure the mixer to
mounting plate.
Outlet adapter and plug
The outlet adapter and plug can be repositioned
dependant on the outlet required (top or
bottom). The adapter has two end fittings, one
is suitable for a 15mm rigid pipe connection and
the other is a flexible hose connection. The O
ring may need to be removed if it is not on the
appropriate side of the hex nut and placed onto
the opposite side
(fig.).
Hot
water
entry
Fig.1
Fig.0
Hose connection end
Outlet adapter
O ring
15mm rigid pipe connection end
Fig.
