Safety Precautions
WARNING
HAZARD:
Injection injury - A high pressure stream produced by this equipment can pierce the skin
and underlying tissues, leading to a serious injury and possible amputation.
See a physician immediately.
DO NOT TREAT AN INJECTION INJURY AS A SIMPLE CUT!
Injection can lead to amputation. See a physician immediately.
The maximum operating range of the gun is 3600 PSI / 245 bar fluid pressure.
PREVENTION:
-
NEVER
aim the gun at any part of the body.
-
NEVER
allow any part of the body to touch the fluid stream.
DO NOT
allow body to touch
a leak in the fluid hose.
-
NEVER
put hand in front of the gun. Gloves will not provide protection against an
injection injury.
-
ALWAYS
lock the gun trigger, shut the pump off, and release all pressure before
servicing, cleaning the tip or guard, changing tip, or leaving unattended. Pressure will not
be released by turning off the motor. The PRIME/SPRAY valve must be turned to PRIME
to relieve the pressure. Refer to the
PRESSURE RELIEF PROCEDURE
described in the
pump manual.
-
ALWAYS
keep the tip guard in place while spraying. The tip guard provides some
protection but is mainly a warning device.
-
ALWAYS
remove the spray tip before flushing or cleaning the system.
- The paint hose can develop leaks from wear, kinking and abuse. A leak can inject
material into the skin. Inspect the hose before each use.
-
NEVER
use a spray gun without a trigger lock and trigger guard in place and in good
working order.
- All accessories must be rated at or above the maximum operating pressure range of the
airless sprayer. This includes spray tips, guns, extensions, and hose.
NOTE TO PHYSICIAN:
Injection into the skin is a traumatic injury. It is important to treat the injury as soon as possible.
DO NOT DELAY
treatment to research toxicity. Toxicity is a concern with some coatings injected
directly into the blood stream. Consultation with a plastic surgeon or reconstructive hand surgeon
may be advisable.
HAZARD: EXPLOSION OR FIRE - Solvent and paint fumes can explode or ignite. Severe injury
and/or property damage can occur.
PREVENTION:
- Provide extensive exhaust and fresh air introduction to keep the air within the spray area
free from accumulation of flammable vapors.
- Avoid all ignition sources such as static electricity sparks, electrical appliances, flames,
pilot lights, hot objects, and sparks from connecting and disconnection power cords or
working light switches.
- Do not smoke in spray area.
- Fire extinguisher must be present and in good working order.
- Place pump at least 25 feet (7.6m) away from the spray object in a well ventilated area
(add more hose if necessary). Flammable vapors are often heavier than air. Floor area
must be extremely well ventilated. The pump may contain arcing parts that emit sparks
and can ignite vapors.
- The equipment and objects in and around the spray area must be properly grounded to
prevent static sparks.
- Use only conductive or grounded high pressure fluid hose. Gun must be grounded
through hose connections.
- Power cords must be connected to a grounded circuit.
!
WARNING
Keep clear of nozzle
“Do not exceed maximum working pressure.”
1
22
Technical Data for your T3
8
0 Spray Gun
Données techniques pour le Pistolet Pulvérisateur T3
8
0
Información técnica de la pistola de pulverización T3
8
0
Technische Daten für Ihre T3
8
0 Spritzpistole
Maximum Working Pressure................................................................
Weight ............................................................................................................................
Hose Inlet Connection............................................................................................
Wetted Parts..............................................................
3
8
00 PSI (2
6
2
bar, 24.5 Mpa)
15.2 oz. (431 g)
1/4 in NPSM Swivel
Stainless steel, polyethylene, nylon, aluminum,
tungsten carbide
