find more information on
www.tristarbot.com
14
Load Model file and slice it, repetier host use cura slicer too, so you can refer
to the cura slicing setting for detail.
When slicing is finished, click Start Print, the commands will then send to your
printer, temperatures will rise up, and then start to print.
Pause or stop printing
If you use graphic LCD controller to make the printing, go to menu->SD
card->Pause print/stop print to pause or stop the printing.
If you use repetier host or other software, there are buttons on it so you can
pause or stop print.
Change Filament
Heat up the nozzle first before you change filament. Go menu->Quick
setting->Preheat PLA/Preheat ABS or Menu->Extruder->Temp.1 and rotate
the knob to raise the temperature of the nozzle. When the temperature reach the
target, then go to menu->Quick setting->Change Filament. The filament then
will be pushed out, and you can load another filament.
IMPORTANT NOTICE:
Please Change filament before you finish the last inch.
The extruder CAN NOT finish all the filament, so if it keep on extruding, the last
small piece will block the nozzle throat, and it
’
s pretty difficult to clean.
