12
Triple Solar assembly instruction PVT heat pump panels UK January 2021
Attention:
Observe the ballast plan of the Sunbeam Calculator for the ballast distribution.
•
After assembling the Sunbeam mounting system, the Triple Solar mounting rails must
be fixed to the Sunbeam triangles by means of cross connectors, see figure 5.1-a.
Figure 3.2-a b cross connector which clamps the mounting rail to the Sunbeam mounting
system
6. Preparing a EPDM/bitumen roof
For pitched EPDM/bitumen roofs Triple Solar delivers roof feet with an EPDM layer. These can be
screwed to vertical wooden beams (50mmx40mm) that are glued to the roof in advance.
The mounting rail is attached to the top of each roof foot with a bracket. Four roof feet are supplied
per panel. The distance between the roof feet is approx. 1000 mm. See also the instructions for
pitched roofs for the distances. This is also the center-to-center distance between the wooden
beams.
Figure 6.1-a
–
Wooden beams glued on the bitumen roof.
