
12-6
EMPRESS
12.1.9 EXTERNAL WATER SUPPLY
The external water source will supply your
motorhome water system with water at city
pressure when the water pump is switched off.
1. Connecting to city water:
a. Turn water pump switch to off.
b. Attach garden hose to city water connection
at water fi ll selection valve. Turn the water
selector valve to city water.
c. Turn on external water supply.
WATER CONNECTION
IMPORTANT
After connecting to the external
water supply, open the faucets in
your motorhome slowly and cau-
tiously. Air trapped in the line can
cause the water to splash into
the sink. A good idea is to drape
a wash cloth over the faucet to
prevent excessive splashing.
IMPORTANT
Some campgrounds have an excessively
high water pressure which can cause
problems. It is a good idea to get a pressure
reducer from your RV center and attach it to
your incoming external water supply hose to
ensure safe pressure for your unit.
to be sure that water enters the heater and
hot water is available for use.
Water from the external supply is prevented
from entering the fresh water tank by means of
a check-valve the water pump .
3.
Disconnecting:
a. Turn off the external water tap.
b. Relieve water pressure on the line by
opening a faucet in the motorhome.
c. Disconnect hose from the motorhome.
d. Replace the protective plug back over the
water connection.
1
2
Summary of Contents for EMPRESS SERIES
