Wash Ionizing/ Collecting Cells
WARNING:
DO NOT USE HIGH PRESSURE STEAM CLEANING
EQUIPMENT TO CLEAN CELLS. THE EXCESSIVE
HEAT AND PRESSURE WILL CAUSE THE PLATES
TO WARP AND IN TURN POSSIBLY CAUSE
EXCESSIVE ARCING.
1. Turn the control switch “OFF” and disconnect power
to the unit.
2. Open the cell access door.
3. Remove ionizer/collector cells and wash in HOT
detergent water. If the collected contaminant is of
extremely dry nature, it can be blown off the cells
with a pressure hose or gently tapping the end plate
of the cell.
4. Remove the mechanical pre-filter. Remove
collected dust or lint by vacuuming or brushing.
Wash with warm, soapy water.
5. Rinse all components thoroughly in warm, clear
water and allow to drip dry completely.
6. Replace pre-filter and ionizer/collector cells. Ensure
the airflow arrows point in the direction of airflow
(towards the blower).
7. Close the access door and reconnect power to the
unit.
8. Turn control switch to “ON”. If arcing occurs or the
indicating light flickers, the components may still be
damp. Turn the unit OFF and allow the cells to dry
completely.
Inspections
The motor and blower on Trion T5200 air cleaners have
sealed ball bearings and never need lubricating.
Belt tension should be checked periodically. When a
moderate force is applied to the belt midway between
the pulleys, the belt should deflect approximately ½”.
CAUTION
Having too much tension on the belts will shorten
the belt life and place undue stress on the motor
and blower bearings.
V. REPLACEMENT PARTS ORDERING
INFORMATION
The following pages contain exploded views and Bills of
Material for the Model T 5200. Use these pages to
determine the part numbers of the items needed. To
order parts contact your local Trion representative and
provide the following information:
a. Unit Model number – located on the data label near
the junction box.
b. Part Number and description – from exploded
views.
VI. WARRANTY
Trion Electronic Air Cleaners come with a 3 Year
Limited Warranty on units and a 1 Year Limited
Warranty on replacement parts. Labor is NOT included.
DO NOT RETURN DEFECTIVE PARTS WITHOUT
RECEIVING A MATERIAL RETURN AUTHORIZATION
NUMBER FROM THE FACTORY.
Seller warrants the equipment of its manufacture to be
free from defects in workmanship and material for a
period of three (3) years after shipment or if applicable –
three (3) years after initial startup of equipment,
whichever occurs first. This warranty is limited,
however, to the repair or replacement of defective
equipment, which is returned, freight prepaid, to Seller’s
factory.
This limited warranty does not apply to any part or
component that is damaged in transit or when handling,
has been subject to misuse, negligence or accident, has
not been installed, operated or serviced according to
Seller’s instructions, or has been operated beyond the
factory-rated capacity or has been altered in any way.
Seller’s liability is limited to replacement of defective
parts or components and does not include any cost of
labor (including, but not limited to, labor required to
remove and/or reinstall any defective part) other than
Trion factory labor.
Trion shall not be responsible for loss of use of any
product, loss of time, inconvenience, or damage to other
equipment or any other indirect or consequential
damage with respect to property whether as a result of
breach of warranty, neglect or otherwise.
6
