LIQUID AEROSOL APPLICATION
INSTALLATIONS
The unit is equipped with a drain hole sized to accept a
½” NPT fitting.
For the collection of liquid contaminant:
1. Install drain fitting to allow for the attachment of a
liquid collection cup or drain hose. A drain fitting is
available from your representative. An “S” trap is
required in the drain hose to ensure proper drainage
of the collected liquid.
2. Raise the front corner of the unit, opposite of the
drain corner, ½” to enable the collected liquid to flow
to the drain sump.
Contaminants to be collected – such as oils in vaporous
state – must be condensed into particulate form prior to
entering the ionizing-collecting cells in order to maintain
the anticipated efficiency. Gases, vapors or any non-
particulate cannot be precipitated and will therefore
pass through the air cleaner. Any condensing that takes
place downstream from the air cleaner defeats the
purpose. Similarly, heavy concentrations of water vapor,
or other matter that becomes highly conductive when
condensed, must be prevented from entering and/or
condensing in the collecting elements to prevent
electrical arc over and shorting.
ELECTRICAL INSTALLATION
All units must be wired directly into the terminal block in
the component box on the access door side of the unit.
Use NEC Class I wiring methods. Size branch circuit
protection in accordance with the NEC. Refer to the
appropriate enclosed wiring diagram in the attached
figures.
WARNING:
EXERCISE ALL THE NORMAL PRECAUTIONS
WHEN WORKING WITH HIGH VOLTAGE AND
COMPLY WITH NEC AND ALL APPROPRIATE
LOCAL CODES.
Check Out for System Start-up
When the installation has been completed, assure that
the equipment is ready for start-up by checking the
following:
A. All construction debris is removed from the ionizing-
collecting cells, drain connections and ductwork.
B. The drain line from the Trion drain basin is clear and
completely connected to its point of termination.
C. Supply line power is available and electrical wiring
is completed to the junction box.
IV. MAINTENANCE
The following instructions are for use by qualified
personnel.
WARNING
RISK OF ELECTRIC SHOCK
These serving instructions are for use by qualified
personnel only. To reduce the risk of electric shock,
do not perform any servicing other than that
contained in the operating instructions unless you
are qualified to do so.
SAFETY NOTE:
Factory designed access to all electrically charged
high voltage components contain electrical
interlocks for the safety of operating personnel. Any
additional access that may be provided in the
system, where there is access to high voltage, must
be equipped with such interlocks. Interlocks are
readily available from the factory.
Cleaning
The pre-filters and ionizer/collector cells should be
removed periodically and soaked in a solution of hot
water and Trion Tridex detergent for 2 to 4 hours, rinsed
thoroughly, and then air dried completely before
reinstalling in the unit.
The frequency of cleaning is dependent on the type of
contaminant being collected. Liquid aerosol requires
less cleaning while welding smoke may require more
frequent cleaning.
The unit should be kept clean to maintain the maximum
collection efficiency.
Note: Trion Tridex Detergent is specially formulated
for use with Trion electronic air cleaners. Use of
other cleaners and detergents, not specifically
approved by Trion, can cause possible failures in
the unit and will void any and all warranties on our
equipment.
5
