Set Up Guide | Floor Scale
7
a. Gently insert the cable connector into
the socket on the underside of the digital
indicator and fully press in.
b. Screw on the connecting collar and
lightly tighten down.
3. Replace the junction box access plate.
4. Connect the AC adapter to the indicator and
then to the wall outlet.
5. Turn the Indicator on. After the power up
sequence the display should indicate Zero. If
it does not, press the ZERO key.
6. When the scale reads Zero it is ready for
use.
CONNECTING A TS-700 SS INDICATOR
-- OR --
CONNECTING A 7600E INDICATOR
(The interface cable is pre-wired to the digital
indicator and requires connecting the five wire
leads into the weighing platform junction box)
1. Feed the five wire leads of the cable up
through the hole in the bottom plate of the
junction box area inside the weighing
platform. Gently pull a generous amount of
slack cable up through the hole.
2. Remove the junction box faceplate.
3. REFERING TO THE FOLLOWING FIG. 3.0
JBOX WIRING DIAGRAM:
a. Using a small Flat head screwdriver,
loosen the terminal screws.
b. Feed the five wire leads into the junction
box through the watertight collar.
