Green LED
Red LED
Software Mode / Current State
On
On
Internal programming occurring
On
Off
Normal full-power operation
Off
Off
No power
Off
Blink X times, then wait
1.5 seconds and repeat
Run-time error detected. The value of
“S” indicates the exact error that is
detected. The table below give more
information of each possible error
Fast blink
(5 time/second)
Fast blink
(5 time/second)
Pairing FOBs mode
Appendix D: Error Codes
There is a red and green LED located to the left of the programming
port. This is visually shown in the Module Connectors and Functions
under Connector Locations. The purpose of these LEDs is to indicate
the mode the system is in.
Fault
Exact Error
Errors
Blinks “X”
CAN error (continue to
Appendix D: Trouble-
shooting)
No CAN Traffic for 2 seconds while vehi-
cle is in gear
1
CAN error (continue to
Appendix D: Trouble-
shooting)
A CAN line is above 5VDC
2
LF receiver not re-
sponding (continue to
Appendix D: Trouble-
shooting)
LF Module Communication Error
3
Push to start works
however the locks are
not working correctly
I/O Expander Module Communication
Error
4
CAN error (continue to
Appendix D: Trouble-
shooting)
CAN Bus Data Erratic No CAN Traffic for
5 seconds
5
Damaged IC chips
(continue to Appendix
D: Troubleshooting)
EEPROM Read/Write Error
6
27
Summary of Contents for 500-1300 e-ASK
