15
A maximum difference of 100dB can be adjusted. When you have found the right
adjustment it can be stored as described above. By using the
MODE-button
another
time you will jump into the next menue. But if you want to stop the adjustments, the
amplifier will leave the
MODE-menue
automatically after ca. 10 seconds and the
MODE-signal
as well as the signal-LEDs will stop shining. Again the volume-display
shows the actual volume-factor.
5.2
Adjustment of the display-brightness
The brightness of the entire display can be pre-adjusted in three steps. In order to do
this adjustment please press the
MODE-button
two times, so that the numeral-signal
above from the
RECORD-signal
shows a symbolical „h“
INPUT
RECORD
SPLIT
OUT 1
OUT 2
MODE
By turning the
VOLUME-button
you can adjust the brightness. The display shows the
selected step
When you found the right adjustment you can store it durably as described above.
By using the
MODE-button
another time you'll jump to the next menue. But if you
don't want to adjust any more, the amplifier will leave the
MODE-menue
and the
MODE-signal
and the signal-LEDs will stop shining as well. Again the volume-display
shows the actual volume factor
5.3
Adjustment of the input-level
Sometimes it can occure that the equipments connected to the
TRV-100
have got a
different volume and that there are volume-differe14nces if switching over. The
TRV-
100
offers the possibility to adjust the sensibility of each input individually. At the third
position in the
MODE-modus occures
the function
l
evel. With the
INPUT-knob
you
can select the input which input-level
you want to change.. With the
volume-knob
then you can lift the
level (turning to the right) or let the
l
evel
down (turning to the
left). The volume-display shows you the degree of the lifting/sinking. With the lifting
the upper LED on the left side is shining additonally, with the sinking the downer LED
on the left side is shining
