12
4.4
Recording possibility between two recording-units
In order to record between two recording units please connect the outputs of
recording-unit A to the i
nput 7
and the outputs of unit B to
input 8.
The recording-
inputs of unit A should be connected to
Tape outputs Rec-1
and of unit B to
Tape
outputs Rec-2.
If you now want to record from unit A to unit B, please switch the RECORD-path on
position 7. Therefore you have to switch button 4 (RECORD) and move the knob
1
to
position 7. Now the recording can be started.
4.5
The output sockets
The
TRV 100
has got two outputs which can be switched undependent from each
other.
To these outputs usually a power-amplifier
or an active-speaker can be connected.
With
output 1
there is an asymmetrical and with
output 2
a symmetrical output
available.
The symmetrical output is good to use in the case of very long connection-cables
between pre-amplifier and amplifier.
The advantage of a symmetrical cabling is that jammings going on to such lines will
be effectively suppressed.
The pin-engagement is as follows: Pin 1 = GND, Pin 2 = + not inverted, Pin 3 =
inverted.
4.6
Remote Sockets
Some power amplifier and active-speakers can be switched on and off by using a
DC-voltage
. Therefore the
TRV 100
has got two
REMOTE-
sockets with a DC-
voltage
of 10V as soon as the
TRV 100
has been switched-on.. Nevertheless the DC-
voltage
can be switched-off within the
MODE-Menue.
4.7
Connection of an equalizer
In order to build an equalizer into the signal-line, the
TRV 100
has got a socket-
quartet with the mark
SPLIT
(
18
).
Connect the output of the equalizer to the sockets
INPUT
and connect the output of
the equalizer to the sockets
OUTPUT.
In order now to build the equalizer into the signal-line, you only need to press the
button
SPLIT
at the
TRV 100
or at the remote-control-unit.
