
81
Raider Installation and Operation Rev. 1.4.2
Analog Control Tray Models Only
1. Strip 1/16" of insulation from each of the flying leads of the 500-443 interface cable and tin.
2. Pull the Control Tray out on the repeater and lift it open so that the SSC module and the TTRC
Audio Board are visible.
3. Remove JU14A from the SSC Module to disable PL/DPL Encode in the station.
4. Disable Repeat on the Station.
5. Solder the Red wire from the interface cable to pin 1 of the Expansion Connector J800.
6. Solder the Black/Shield wire to pins 7,8,9,10 on the Expansion Connector J800.
7. Solder the White wire to pin 39 on J800.
8. Solder the Orange wire to the center pin of JU14-JU15.
9. Solder the Yellow wire to the pad where R893 connects to pin 13 of U834 on the SSC Module.
10. Solder the Blue wire to TP9.
11. Set the Raider's jumpers and switches per the chart below.
12. Perform the Alignment Procedure in this manual to complete the installation.
Motorola MSF5000 Repeater Interface - page 1 of 1
This cable is available from Trident.
Please contact your Trident Representative for details.
All RF equipment is unique to its own system installation. These jumper and switch indications are meant
to be used as initial settings. Adjustments to these settings may be required, dependent upon your system
configuration.
OUT
IN
IN
OFF
OFF
OFF
ON
W22 W30 W26 TX DTA RX DTA TX DCS RX DCS
Raider Jumpers Raider Invert Switches
Raider
DB-25 Male
1
White - Discriminator Input
Pin 39 on the Expansion
14
Connector J800
2
15
3
Yellow - TX Audio Output
Pad where R893 connects to
16
pin 13 of U834 on SSC Module
4
17
5
Orange - TX Data Output
Center pin of JU14-JU15
18
6
19
7
20
Blue - PTT Output
TP9
8
21
9
22
10
23
11
24
Drain - Ground
12
25
Black - Ground
13
Red - 11 to 16 volts DC
(+) Pin 1 on the
Expansion Connector J800
15K
22K
}
Pins 7, 8, 9, 10 on the
Expansion Connector J800
Summary of Contents for Raider
