Trident Raider, Installation And Operation Manual

Page: 66 / 94

66
Raider Installation and Operation Rev. 1.4.2
Using the Motorola Radio Service Software (RSS), installed on a suitable IBM compatible
computer, and these instructions, the Motorola MTR2000™ station can be configured for use with
the
Raider
(dispatch only) and
Marauder
(dispatch & interconnect) series controllers. This
supplement supports MTR RSS revisions up to R03.02.01. Answers to specific questions
pertaining to the use of the RSS can be found in the Radio Service Software Start-up Manual
provided with your software.
MTR2000 Setup Instructions
1. Start the Radio Service Software (RSS) and connect the MTR2000 station to your computer.
Read the contents of the station’s Codeplug.
2. From the
Station Configuration
window, click on the
Edit Config
button. The Station
Configuration window will appear. (Fig. 1)
3. The options in the Configuration window marked by the arrows are items that must be selected
just as they are shown. Other options may or may not be selected depending on the exact
options installed in the MTR2000 or your particular installation.
4. Now click on
OK
to return to the
Station Configuration
window. The pull down menus will
become active now.
5. Click on
Personality
, and click on
RF Options.
Compare the window that opens with Fig. 2
and make any necessary changes in the RSS. When done, click
OK
to close the window.
6. Click on
Personality
, and click on
Wireline
. Compare the window that appears with that in
Fig. 3 and make any necessary changes in the RSS. Everything must appear exactly as shown.
The options in the Configuration window marked by the arrows are items of particular
importance. When done, click
OK
to close the window.
7. Click on
Personality
, and click on
TRC Commands
. All eight
Command List Options
should
show
None
. When done, click
OK
to close the window.
8. Click on
Personality
, and click on
Channel Information.
A window, as in Fig. 4, will appear.
Make sure that the
TX Idle
frequency is the same as the
Transmit
frequency. Re-enter the
frequency if necessary.
9. In the upper left hand corner of the
Channel Information
window under
Option,
click on
Audio.
A window as shown in Fig. 5 will appear. Every option in this window must be set to
match Fig. 5 exactly.
Alarm Tone
and
Call Sign
are the only options that may differ. The
options in the Configuration window marked by the arrows ( ) are items of particular
importance.
10. Continue on by clicking
PTT
, in the
Option
window. A window as shown in Fig. 6 will appear.
Make sure that you correctly select the two options as indicated by the arrows. Failure to do
so can cause loss of transmit data.
11. The next item to be selected from the
Option
window is
Encoder
and
Decoder.
These two
should both have
None
in the
Type
window as indicated by the arrows in Fig. 7 and Fig. 8. Click
OK
to close the
Channel Information
window.
12. Write the current profile to the station and save it to disk. As soon as you get the
Station
Successfully Written
message, proceed to the alignment portion of these instructions.
Motorola MTR2000 Repeater Interface - page 1 of 10