TriboServ FlexxPump4 BXXX-EXT, User Manual

Page: 44 / 58

Revision: 0
FlexxPump4 B
User Manual
44 EN-
The microelectronics integrated in the FP4 B permanently monitors the status. In the
event of irregularities, an addressed error message is displayed on the LCD. The red
LED flashes every 5 seconds and also signals an error optically.
LCD Name Description Remedy
Error
E1
Cartridge
empty

Place a new cartridge on FP4
B (see chapter 7.2).

No confirmation of the error
necessary; it is automatically
cleared after the remedial
action.
Error
E2
Overload; the
back pressure
at the lubricati-
on point is too
high.

Check the lubrication point
and eliminate the cause of the
fault.

Switch FP4 B off (OFF) and
on (ON) again.
Error
E3
Battery empty

Switch FP4 B off (OFF).

Replace the battery together
with the cartridge (see chapter
7.2).

Switch FP4 B on (ON).
Error
E4
Fatal error
 Disassemble the FP4 B and
return it to the manufacturer
together with the lubricant
cartridge and a description of
the fault.

A fatal error usually occurs
in the electronics of the FP4 B
and cannot be repaired by you
on site.

The address of the manufac-
turer can be found in chapter
I.II.
E2
E3
E1
6.4 Error codes
E4