![background image](http://html1.mh-extra.com/html/triax/upm-1400/upm-1400_user-manual_1160850017.webp)
UPM 1400
17
EN
F3 - DiSEqC settings
F4 - return to other functions
Satellite, spectrum: constellation diagram
The screen shot below shows the rating and constellation diagram of a QPSK DVB-S modulated transponder by
pressing the F2 key
The UPM 1400 evaluates the signal parameters of a channel and displays them graphically using a constellation
diagram. Ideally, the device receives a noise-free and interference-free signal. This is shown in 4 quadrants over
many small dots which are grouped together and form circles.
If the device receives a bad signal, this has a corresponding effect on the display. The points of the 4 quadrants then
no longer group together in structured circles, but spread out in a less structured way.
Explanation of parameters:
Sat-HF
- HF Transponder Frequency
NIT
- automatic satellite detection
SR
- symbol rate
Polarization
- transponder polarization
22K
- Shows if 22 KHz is enabled
DiSEqC 1.0
- DiSEqC command display
Modulation
- Displays the type of modulation
FEC
- display of applied error correction
POW
- signal level in dBuV (can also be set to dBm in the settings menu)
MER
–
signal quality based on measurement of modulation error rates
CBer
–
signal quality based on measurement of bit error rate before error correction
VBer
–
signal quality based on measurement of bit error rates after error correction
Function Key Options
:
F1 - starts searching for stations on the corresponding transponder
F4 - back to spectrum
Satellite plotting, introduction
This tutorial walks you through the complete installation of a satellite reception using the example of the Astra
located at 19.2° East.
Summary of Contents for UPM 1400
Page 3: ...UPM 1400 3 EN ...
Page 32: ...UPM 1400 EN 32 Notes ...