12
TRI TOOL INC.
92-1306 : Rev. 090225
NOTE:
The shoulder screw (Item C) holding the hoist ring to the lifting bracket is to be
torqued at 25 ft-lbs (34 N m).
There are eight (8) cap screws that hold each gear cover (Item D) onto the main
housing. They are torqued to 50 ft-lbs (68 N m).
LUBRICATION
The drive gears require a grease such as “Chevron Ultra-Duty grease EP NLGI 2”
(P/N 68-0024).
The slide rails and tool blocks require a light oil such as SAE 10 light machine oil.
A light film of all purpose grease may be used, but it must be checked for grit
contamination frequently.
The bearings in the hydraulic motor(s) are sealed and do not require any lubrication.
Shoulder Screw
(Item C)
Gear Cover
(Item D)
Lathe Stand
(Item B)
Main Torque Housing
(Item A)
Torque Locations
