10
TRI TOOL INC.
92-1306 : Rev. 090225
CAUTION:
MAINTENANCE
All Components should be cleaned and coated with a light film of oil prior to use.
If the Model 236B is operated in the vertical position, Headstock facing up,
the chips and/or other debris should be removed after each bevel cut has
been completed.
Tool Life may be severely shortened, unless chips and/or other debris that
have been deposited on or around the Headstock during the machining
operation are removed.
Daily Maintenance should include a visual inspection of all parts for damage due to
chips, impact or improper use.
Repair or replace broken or damaged parts as necessary.
Wipe the machine clean of cutting fluids, dirt and grime and then coat it with a light
film of oil.
Weekly maintenance should include checking the mandrel and wiping the oil and
grime from the surface and then relubricating it with a light film of oil.
Re-lubricate the Main Bearing via a grease fitting on the Headstock.
Re-lubricate the Main Gear via a grease fitting on the Main Housing.
TIGHTEN THE FRONT BUSHING
Rotate the feed handle to extend the mandrel outward to the limit line.
Remove the tool modules from the headstock to provide working room for using the
spanner wrench during the locknut loosening.
Loosen the two (2) flat head screws in the locknut on the front of the headstock.
Tighten the first lock nut on the front of the center torque housing.
Tighten the two (2) flat head screws in the lock nut.
