Page 8
O
PERATOR
TECHNIQUE
Crimp location on the contact, and depth of crimp, are entirely TAC dependent. The
operator only need select (if applicable) the proper "G" dimension setting and initiate
the crimp cycle by inserting the conductor into the contact and depressing it by
applying slight pressure. A conductor whose strands are not visible through the contact
inspection hole (if applicable) was probably not stripped to proper length.
Operators usually get the "feel" of the machine within 15 minutes of use. Noise
generated by the device is minimal; operators have been observed to develop a
rhythm of insertion and withdrawal based on the unique sounds generated by the
device. Crimp rates of 1800 crimps per hour have been attained.
T
AC
-17X
S
PECIFICATIONS
TAC-17X
most shouldered and
shoulder-less contacts
Weight
110 lbs
Air
approx. 10 CFM @ 85 PSI
Input Air Connections
3/8" ID
Electric
115 VAC, 60 cycle, 5 AMP
Europe 220 VAC, 50 cycle, 5 AMP
Dimensions
17” wide x 21” deep x 21” height
Contact Feed Rate
approx. 1800+/hr
Summary of Contents for TAC 17X
