Page 17
O
PERATING
P
ROCEDURES
I
NTRODUCTION
The TAC series crimpers are simple to operate. No previous experience with crimpers
of any kind is required; however, operators need to exercise reasonable care when
operating the TAC and should be familiar with acceptable crimp criteria. No
adjustments to the equipment should be made unless specific procedures in this
manual are followed, and then only when authorized.
This section assumes the TAC has been set-up properly and that Crimp Verification
has been performed (Sections 2 and 3).
Read this section completely before operating the TAC.
Perform the following steps to operate the TAC. Make sure AC switch is on and sleeve
valve is closed
Step 1.
Select the desired feeder bowl on-off switch from HMI display.
Step 2.
Observe that the feeder-bowl is vibrating and transporting contacts to
the top of the bowl. If parts are moving too slowly or too fast, adjust
feeder bowl amplitude
N
ORMAL
OPERATION
Section 4
Summary of Contents for TAC 17X
