- 6 -
Factory Default Settings
Password
Default setting
: left blank.
Setting up password
: When using Telnet or Web (HTTP) to configure the device, press
Enter
to login the configuration for the first time. It is recommended that you set a password for
security and management purpose.
Password forgotten?
If you forgot the password, you can reset the device to factory setting.
Refer to the section titled “
Factory Reset
” for details.
Local and Global Port Addresses
The LAN parameters of the product are pre-set in the factory. The
default values
are shown
below.
Local Port
Global Port
IP address
192.168.1.254
Subnet Mask
255.255.255.0
DHCP server function
Enabled
DHCP client function is
enabled
to automatically
get the Global port
configuration from ISP.
IP addresses for
distribution to PCs
253 IP addresses continuing from 192.168.1.1 to
192.168.1.253
Table 3: Local and Global Port Addresses
Information from ISP
Before you start configuring this device, you should gather the information as illustrated in
the following tables and keep it for reference.
For CATV dynamic mode
:
Adapter Address
Some Internet Service Providers (ISP) requires that you
register the MAC address of your network card/adapter, which
was connected to your cable or DSL modem during
installation. If your ISPs require MAC address registration,
find your adapter’s MAC address by doing the following:
Under Windows 98: Click
Start
?
Run
, type in “
winipcfg
”.
Under Windows ME or 2000, Click
Start
?
Run
, type in
“command”, and press Enter. At the DOS prompt, type
