TRENDnet TFM-560E, User Manual

Page: 52 / 54

- 49 -
APPENDIX B: S-REGISTERS
S-Registers, “ATSn=x”
Regist
er Dec. Function & Description Default
S0= 0 - 255 Set the number of the rings required
before the modem automatically
answers
a call. Set “S0=0” to disable auto-
answer mode 000
S1= 0 - 255 Count the incoming rings and store the
value to this register. The value of this
register is incremented with each ring. If
no rings occur over an 8 sec. interval,
this register is cleared. User can read
but should not change this value 000
S2= 0 - 255 S2 holds the decimal value of the ASCII
character used as the escape character.
The default value (043) corresponds to
an ASCII character “+”. A value of 128
to 255 disables the escape process, i.e.,
no escape character will be recognized 043
S3= 0 - 127 Hold the decimal value of the Carriage
Return <CR> character used as the
command line and result code
terminator. Pertain to asynchronous
operation only 013
S4= 0 - 127 Hold the decimal value of the character
recognized as a line feed.The line feed
control character is output after the
carriage return control character if
verbose result code are used. 010
S5= 0 - 32,
127 Hold the decimal value of the character
recognized as a backspace. The modem
will not recognize the backspace
character if this register is set to a value
greater than 32 008
S6= Set the length of time, in seconds, that
the modem must wait (minimum 2
seconds even if the value is less than 2)
after going off-hook before dialing the
first digit of the telephone number
2 - 65 For international version 003
S7= Set the time, in seconds, that the modem
must wait before hanging up because
carrier is not detected